UPDATED Arduino Digital Pressure Sensor Module
Arduino powered sensor for reading Barometric Pressure (altitude) and Temperature. Built in temp. compensation, Analog/Digital Converter and Control.
Full on board calibration.
4 modes for pressure: Ultra low power, Standard, High Resoultion, Ultra High Resolution.
Power: 3.3V or 4.5-12VDC using On-board 3.3V Regulator
Peak Current: 1mA max During Conversion
Noise: <0.02hPa (17cm)
Detector: BOSCH BMP180
Outputs: I2C
Data Rate: 3.5mHz
Word Length: 16 /19 bit pressure 16bit temperature
Pressure Range: 300-1100hPa
-500 to +9000M above sea level
Conversion Time: 4.5mS to 25.5 depending on Mode
Temperature Range: 0-65C
5 Pin I/O header. L: 9/16” W: 1/2” H: 1/8” WT: .002
