High Current Buck Converter 5VDC with USB Smart Charger
|Item Number: 34664 PS|
5VDC output High Power Buck converter with USB Charger.
Terminal Strip and 5.5/2.5 mm coaixal jack for input
Terminal Strip for 5VDC Output
USB Type A Jack for Charger out and control
(fast charging identification chip RZC7512)
Output: Voltage: 5VDC (Fixed)
Current: See Chart
L: 2-9/16" W: 1-1/16" H: 5/8" WT: .05
|For many years I have used double-sided tape to mount similar PCBs. Sometimes hot-melt will work as well, if the board does not get hot of course. A bit of care is always useful too.|
|- Bob, GA|
||Lots of ripple
|10 mV ripple with no-load. 50 mV with ~1A. But if youre not worried about that, its a pretty good deal.|
||Nice except for mounting.
|I mounted mine with wire ties that have screw eyes on the end. Works fine.|
|- Roland Phillips, FL|
||Very useful buck converter not boost
|This is a buck converter - the specs make that clear.
This charges my iPhone, which wont charge from a powered USB hub that doesnt respond to USB charge protocol, though some other devices do. Doesnt even get warm when drawing about a half amp at 12V. Im building an off-grid hurricane backup power supply and needed something that would charge any USB device. This seems to be it.
Id have given it 5 stars if there was some reasonable way to mount it, but there are no holes and the components come to the edges. Im still trying to figure that out.|
|- Steve, FL|