USB to TTL Bridge Control FT232RL Module for Arduino
USB TO TTL Module for Arduino & Microcontrollers
USB-STC-ISP Module provides Support for USB 1.1/2.0 to TTL devices. Full Duplex asynchronous serial device to a USB host. Upgrade RS232/422/485 to USB
Supports Windows® up through 7, linux 2.4 & up.
Chip: FTDI FT232RL Bridge controller~| ^
Power: 5, 3.3VDC From Host
Selectable 5 or 3.3V out for external Logic
Connections: 2 X .1” pitch holes for CBUS0-4, Reset
DTR, RTS, DSR, DCD, RI, CTS
4 Pin (.1”) header for connection to TTL devices
USB 2.0 Type A Male
LEDs for Power, Rx & Tx
Drivers available at: www.ftdichip.com L: 2-1/16" O/A W: 11/16" H: 1/2" WT: .02
WARNING: This product can expose you to chemicals including Nickel which is known to the State of California to cause cancer and which is known to the State of California to cause birth defects and/or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Click to see Why is this here?
As of August 2018 the State of California has changed the requirements of the “Prop 65” law. We now must list on our website any possible chemicals the can cause cancer, birth defects or reproductive problem.
As an example:
ABS plastic contains styrene
PVC wire insulation can contain Di(2-ethylhexyl)phthalate (DEHP)
electrolytic capacitors can contain Ethylene glycol
Brass can contain Lead
flame retardant pc boards can contain Tetrabromobisphenol A (TBBPA)
Aluminum alloys can contain Chromium
To put it simply we are a small company and do not have the resources to test every single part, so we list every thing as hazardous. Please recycle all electronic parts responsibly and under no circumstance eat, drink or smoke these parts and wash your hands after touching!
No problems with the programmer on either part. You can use this on the raspberry pie as well. For serial comm and not have to get out a monitor and keyboard. It has all the I/O/signals to do a full blown modem. I did not get the cheaper one but sure it is fine too.