USB Power & Charger Monitor, Universal Single Display


USB Power & Charger Monitor, Universal Single Display
Stock Number: 31858 ME
 Review Average:  
 Number of Reviews: 2
 View ReviewsReview this item
$9.95


Availibilty: In Stock   Units: 11
Quantity 



SHARE
    
     Email this to a friend     

Detailed Description

Allows you to monitor your cell phone, tablet, Pads, external drives etc. that plug into a computer USB Port or wall charger with USB connector. Single USB Type A Male plug on 4” cable for input. 2 Output USB Female Type A ports. Current displayed is total for both Ports.
Input Voltage: 3.2~10V Charger/Port dependant
Current Available: >3A Charger Dependant
Display: Dual 3 Digit Red LED, .28" characters
Port I: Universal port with both Data transfer and charging. For use with original cell and replacement tablet, Books and other USB device chargers. Also supports OEM high current chargers for IPad, IPhone and Samsung S4 at reduced charge rate.
PortII: Charging Port only no Data transfer. For use with original cell and replacement tablet and other USB device chargers. Also supports OEM high current chargers for IPad, IPhone and Samsung S4.
When using USB Computer Ports Current is limited and charging will take longer.
L: 2-3/4" W: 1" T: 9/16 WT: .04


California Proposition 65 Warning WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
(This item was manufactured prior to August 31st, 2018)



 Product ReviewsClick here to review this item
This device killed the USB capabilitys of my lap top!
My lap top was working fine until I plugged in this device and now I have no USB functions. The device never even lit up. I only gave it one star because there is not a negative rating.
- Mark Patience, NY
 
USB Monitor
Works as stated. Nice unit with large easy to read displays. There are additional modes not listed and a undocumented. There is a small pushbutton on top that changes modes. So far figured out the following: Volts Amps -- Two line display C = Capacity??? Appears to be total power consumed - P - = Power??? Appears to be Watts There are also several multi modes which cause the display to <alternate> the displayed functions: C uA = Capacity / Volt Amps P uA = Power / Volt Amps C P = Capacity / Power C P uA = Capacity / Power / Volt Amps Capacity is accumulative, all others are instantaneous. Capacity is cleared by holding down the button until the display flashes and then pressing button again. This is a pretty slick little box!
- Lucky Dog, WA