Turbidity Sensor for Microcontrollers
Used to detect the amount of solids in a liquid (suspended particles).
The liquid flows between an optical sensor that provides an output signal.
Wiring side of the sensor is not waterproof
Range: ~0-3.5% (0-4550 NTU (Nephelometric Turbidity Units))
Output: Analog: ~0-4.5V (Value will decrease as the turbidity increases) Digital: Low= ~0V High=~5V
Adjustable Digital Trigger set point
Response Time: ~500mS
Operating Temperature: -10-80C
Connection: 0.1" Pitch Header Pins
8in. Sensor to Board cable
BOARD: L: 1-3/16" W: 13/16" (Body) H: 7/16"
PROBE: L: 1-3/8" W: 1-1/4" H: 1-1/2: WT: .04
WARNING: This product can expose you to chemicals including Nickel which is known to the State of California to cause cancer and which is known to the State of California to cause birth defects and/or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Click to see Why is this here?
As of August 2018 the State of California has changed the requirements of the “Prop 65” law. We now must list on our website any possible chemicals the can cause cancer, birth defects or reproductive problem.
As an example:
ABS plastic contains styrene
PVC wire insulation can contain Di(2-ethylhexyl)phthalate (DEHP)
electrolytic capacitors can contain Ethylene glycol
Brass can contain Lead
flame retardant pc boards can contain Tetrabromobisphenol A (TBBPA)
Aluminum alloys can contain Chromium
To put it simply we are a small company and do not have the resources to test every single part, so we list every thing as hazardous. Please recycle all electronic parts responsibly and under no circumstance eat, drink or smoke these parts and wash your hands after touching!