Neat combination of remote controlled driver board & a small NEMA 11 gearhead Stepmotor
Driver Board has a I/R Receiver & a microprocessor that is used to control speed & direction, number of steps etc. of the gearhead stepper using the remote
Motor: P/N 28BYJ-48
Coil: Unipolar/5 Lead, 200 ohm
Step: .0879deg/step (5.625 Deg/step , 1/64 ratio)
Rate: 500pps max
Hold Torque: >350g-cm
20mm long X 28mm Dia. with 5mm dia. double “D” X 9mm brass shaft. 8" motor leads, 2 mounting ears
Board: I/R receiver. Built in STC15L104W pre-programmed microcontroller. Connector for Motor, Header for selecting internal/external Motor power. Header for power & limit switch
Power: 3.8-4.6VDCVDC
4 Pin .1in. Pitch Headers for power & limit switch
5 Pin XH-5P socket for connection to Motor
4 Pin .1in. Pitch Header for motor power selection
Remote: Palm size with 21 buttons
WT: .12
