INPUT: 9-40CVDC (24 Nominal) OUTPUT: Selectable up to 3.5A max. STEP: Full & 1/2, 1/4, 1/8, 1/16, 1/32 Microstep
Full bridge driver for 4 or 6 wire hybrid stepmotors.
Automatic drop to Hold current with no Step Input.
Switch Selectable output current. .5A-3.5A
Over temperature & current Protected.
Under Voltage Shutdown
Opto isolated Step, Direction & Enable Inputs. (+5V Level)
Terminal strips in/out. Power and Run LEDs L: 3" (76cm) W: 2" (51cm) H: 1-1/2" (38cm) WT: .5
WARNING: This product can expose you to chemicals including Nickel which is known to the State of California to cause cancer and which is known to the State of California to cause birth defects and/or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Click to see Why is this here?
As of August 2018 the State of California has changed the requirements of the “Prop 65” law. We now must list on our website any possible chemicals the can cause cancer, birth defects or reproductive problem.
As an example:
ABS plastic contains styrene
PVC wire insulation can contain Di(2-ethylhexyl)phthalate (DEHP)
electrolytic capacitors can contain Ethylene glycol
Brass can contain Lead
flame retardant pc boards can contain Tetrabromobisphenol A (TBBPA)
Aluminum alloys can contain Chromium
To put it simply we are a small company and do not have the resources to test every single part, so we list every thing as hazardous. Please recycle all electronic parts responsibly and under no circumstance eat, drink or smoke these parts and wash your hands after touching!
I have not purchased this item yet, but it looks like quite a bargain at the price. So I looked at the reviews. It appears to me that the reviewer overlooked the information in the product data sheet showing that the control inputs are via floating opto-coupler inputs. Therefore each input is independent of the others and may use common ground or common positive supply or any combination. While I also like to have detailed instructions for each device I use, I believe the information in the data sheet is adequate and sufficient, albeit sparse. Regarding the lack of information on how the controller responds to control inputs, a few minutes experimenting at the workbench will reveal that.
instructions are very lacking !
If you already are familure with the device they are usefulI am sure. If you are not, and dont want to hook it up wrong an burn it up, then the instructions do not give enough details... A sample circuit of a typical hook up would be very useful in this situation. A full explanation for each input would be a BIG help. for example Dir+ = direction CW/CCW & Dir- = Direction return ?? Do you put a + voltage on dir+ with respect to dir- ? does this have to be an independent signal or can it be common to the GND ? or are we using negative logic and a + makes it go CCW.. All inputs lack a full description.. Even though it is an inexpensive unit, I dont want to hook it up wrong and burn it up on the first try at putting power to it. It is a good price, and looks like a quality product, Just not sure how to wire it.
Super quiet. I used this as a replacement for my CNC router.
It replaced TB6560 driver and made a huge difference. Very quiet. No resonance smooth stepping.