/ /

RFID/NFC Reader/Writer for Arduino

Stock No: 31111 MP

Review Average:

Number of Reviews: 2

View Reviews | Review this item

$4.95

Availibilty: In Stock Units: 32

Quantity

SHARE
Tweet		Share

Detailed Description

RFID kit for Arduino microcontrollers.
MIFARE RFID Reader/Writer set up that includes a MF522 reader Board, a S50 Plastic Card and a small KeyFOB.
Supports ISO14443A Transponder protocols and CRYPTO01 encryption algorithm. Open source software available at www.arduino. com and several other sites.
Module: Based on the MFRC522 IC
Frequency: 13.56MHz
Power: 3.3V @ 26mA Active ,<80uA Sleep mode
Read/Write Time: <2mS
Distance: <10cm
Data Transfer Read/Write: 424kbs
Interface: SPI
Module includes straight & right Angle Headers that you have to solder.
Size: 60L X 40W X 6mm Without header
Card: NFC Smart Card/Tag MIFARE S50, Blank card.
Memory: 1K EEPROM (768Available)
Comm. Speed: 106 Kbaud
Freq: 13.56MHz.
# of Writes: 100K
Size: 86 X 55 X .9mm
Compatible With most NFC supporting Android Devices.
Keyfob: NFC MIFARE 1K ISO 14443A
Freq: 13.56MHz.
# of Writes: 100K
Waterproof ABS Case
Size:32W X 40L X 4mm
WT: .06

Additional Media
Cards: Order #: 31112 MP

WARNING: This product can expose you to chemicals including Nickel which is known to the State of California to cause cancer and which is known to the State of California to cause birth defects and/or other reproductive harm. For more information, go to www.P65Warnings.ca.gov

Product ReviewsClick here to review this item

	OK For Arduino
I tried to interface this device with a PIC SPI, and found it impossible to deal with. Not even the firmware version register would send the correct byte value. If you are using an Arduino and you download existing code libraries, you can probably get it to work, but otherwise, review the MCRF522 datasheet first. Its completely incomprehensible unless you are already an expert. Glad I spent only $5 on it.
- Bob, CO

	Good kit
I have used all of these products separately, nice to see they have a kit where you can buy all 3 at once.

RFID/NFC Reader/Writer for Arduino

You may also like: