Not for use below 20Amps
Dual Display AC Volt and Amp Panel meter
Round 3 digit color LED with color lens.
Character Height: 6.5mm Voltage Range: 50-500VAC 50/60 Hz Sine Wave Only
Resolution: 1V Amp Range: 20-99.9A
C/T Pigtail: 170mm
Meter Pigtail to C/T: 140mm
Mounting Hole: 22mm
Temperature: -25"C"~ +65"C"
Humidity: <98% DIA: 29.3mm L: 50mm WT: .09
WARNING: This product can expose you to chemicals including Nickel which is known to the State of California to cause cancer and which is known to the State of California to cause birth defects and/or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Click to see Why is this here?
As of August 2018 the State of California has changed the requirements of the “Prop 65” law. We now must list on our website any possible chemicals the can cause cancer, birth defects or reproductive problem.
As an example:
ABS plastic contains styrene
PVC wire insulation can contain Di(2-ethylhexyl)phthalate (DEHP)
electrolytic capacitors can contain Ethylene glycol
Brass can contain Lead
flame retardant pc boards can contain Tetrabromobisphenol A (TBBPA)
Aluminum alloys can contain Chromium
To put it simply we are a small company and do not have the resources to test every single part, so we list every thing as hazardous. Please recycle all electronic parts responsibly and under no circumstance eat, drink or smoke these parts and wash your hands after touching!
I bought two of these meters and installed one of them in the power distribution panel for my shop so I could monitor the current draw of my power equipment and avoid blown fuses. The Voltage readout works well and agrees very closely with two other MPJA AC meter modules 32404 ME and 31496 ME I bought for other purposes.
The Current readout however is very inaccurate at low currents. In particular, it reads 0.0A until the actual current is well over 2 amps and
continues to read low at higher currents up to 12 amps, the highest I checked. This was the case with both 35280 ME modules I had.