Sold In Packs of 10
Solder-Shrink terminals for splicing & waterproofing wires.
Solder & seal in one operation. Pre-fluxed Low Melting solder preforms, clear shrink sleeve with a color hot melt sealant.
Shrink Ratio: 2/1
Solder Temp: ~150deg. "C"
Shrink Temp: ~130deg. "C"
Operating Temp: -55~125deg "C" WT: .02
WARNING: This product can expose you to chemicals including Lead which is known to the State of California to cause cancer and which is known to the State of California to cause birth defects and/or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Click to see Why is this here?
As of August 2018 the State of California has changed the requirements of the “Prop 65” law. We now must list on our website any possible chemicals the can cause cancer, birth defects or reproductive problem.
As an example:
ABS plastic contains styrene
PVC wire insulation can contain Di(2-ethylhexyl)phthalate (DEHP)
electrolytic capacitors can contain Ethylene glycol
Brass can contain Lead
flame retardant pc boards can contain Tetrabromobisphenol A (TBBPA)
Aluminum alloys can contain Chromium
To put it simply we are a small company and do not have the resources to test every single part, so we list every thing as hazardous. Please recycle all electronic parts responsibly and under no circumstance eat, drink or smoke these parts and wash your hands after touching!
I wish I had come across these sooner as I could have saved a ton of time soldering! Just slide it on, twist the wires together, center the solder over the wire, heat it up in the center until the solder melts and then heat the heat shrink for a solid moisture proof joint I use a heat gun but you could use a mini torch etc as well