Enclosed mini wide range LED dimmer control uses PWM to vary the brightness of single color LED strips or boards. Adjustment pot on top.
Terminal strips for Power & LED strip connections.
NOTE: LOAD MUST BE CONNECTED BETWEEN OUT V+ & OUT V-
Output: 8A (96W)
Control Range: ~0%-99%LED Brightness. L: 3-1/2 W: 2-3/8 H: 2-1/8 WT: .12
WARNING: This product can expose you to chemicals including Nickel which is known to the State of California to cause cancer and which is known to the State of California to cause birth defects and/or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Click to see Why is this here?
As of August 2018 the State of California has changed the requirements of the Prop 65 law. We now must list on our website any possible chemicals the can cause cancer, birth defects or reproductive problem.
As an example:
ABS plastic contains styrene
PVC wire insulation can contain Di(2-ethylhexyl)phthalate (DEHP)
electrolytic capacitors can contain Ethylene glycol
Brass can contain Lead
flame retardant pc boards can contain Tetrabromobisphenol A (TBBPA)
Aluminum alloys can contain Chromium
To put it simply we are a small company and do not have the resources to test every single part, so we list every thing as hazardous. Please recycle all electronic parts responsibly and under no circumstance eat, drink or smoke these parts and wash your hands after touching!
Dims a 5m LED strip from full brightness down to about 10% and then cuts out right at 0%. I used a 12v switched PS as input. I peeked inside, there is a controller board about 2x4cm with two 8-pin SMT chips and two 3-pin chips. Reversed polarity on input did not hurt it. Oops!