We do not include any printed materials of the following "Data Sheets". You will need to print from the following Document(s).
MFG: HANTRONIX P/N: HDM128GS24 Resolution: 240X128 Dot Size: .4 X .4mm Dot Pitch: .45mm Specifications/Features: 2.5 X 4.375 View area, Transflective type Dot Matrix display with white LED Backlight. Built in Toshiba T6963 controller.
Requires 5VDC supply
LED backlight requires series resistor to limit current to <= 900mA
20Pin right angle header for Data 8in leads for Backlight. L: 6" W: 4-1/2" O/A T: 1/2" WT:.5
WARNING: This product can expose you to chemicals including Nickel which is known to the State of California to cause cancer and which is known to the State of California to cause birth defects and/or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Click to see Why is this here?
As of August 2018 the State of California has changed the requirements of the Prop 65 law. We now must list on our website any possible chemicals the can cause cancer, birth defects or reproductive problem.
As an example:
ABS plastic contains styrene
PVC wire insulation can contain Di(2-ethylhexyl)phthalate (DEHP)
electrolytic capacitors can contain Ethylene glycol
Brass can contain Lead
flame retardant pc boards can contain Tetrabromobisphenol A (TBBPA)
Aluminum alloys can contain Chromium
To put it simply we are a small company and do not have the resources to test every single part, so we list every thing as hazardous. Please recycle all electronic parts responsibly and under no circumstance eat, drink or smoke these parts and wash your hands after touching!
Very fast transaction! Product exactly as described. Great seller!
Shipped fast and the item was packed really well.
Great LCD display, nice bright backlight
I got this to replace the old CCFL display in my Alesis Fusion. It runs and looks great. The contrast levels are not as high as some LCDs because its a transflective display so it looks good even with bright ambient lighting where most LCDs are hard to see.
Before installing the new display I spent some time with a variable power supply and some power resistors determining what current levels provided good illumination without getting the LED module too hot. I found that between 150 and 200mA the backlight was nicely bright while still running cool. At 300mA and above the LED module got too hot. Forget the datasheet rating. If you run this at 800mA I seriously doubt it will last long. 400mA got the LED bar too hot to touch!
Overall, an amazing value and very well built. These are not low-quality displays as another reviewer implied.
Inexpensive replacement display for Alesisi Fusion & Akai MPC5000
Plug in replacement for Alesis Fusion & Akai MPC500
The LED back light can be connected to dimmer control by the power leads that went to the Dimmer PCB and the Dimmer PCB & Inverter PCB that were used to power the CCFL back light can be eliminated.
Just what I needed.
I bought 2 and they work great. I used a dspic30f4013 and mikroelektronicas glcd library. I like the fact it has a built-in negative voltage generator and only needs a 5 volt supply.
- Mark S, CA
Tried like hell and couldnt get it to work.
no wonder why it was so cheap. I think I just got a bad board.