WARNING: This product can expose you to chemicals including Nickel which is known to the State of California to cause cancer and which is known to the State of California to cause birth defects and/or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Click to see Why is this here? As of August 2018 the State of California has changed the requirements of the “Prop 65” law. We now must list on our website any possible chemicals the can cause cancer, birth defects or reproductive problem.
As an example:
ABS plastic contains styrene
PVC wire insulation can contain Di(2-ethylhexyl)phthalate (DEHP)
electrolytic capacitors can contain Ethylene glycol
Brass can contain Lead
flame retardant pc boards can contain Tetrabromobisphenol A (TBBPA)
Aluminum alloys can contain Chromium
To put it simply we are a small company and do not have the resources to test every single part, so we list every thing as hazardous. Please recycle all electronic parts responsibly and under no circumstance eat, drink or smoke these parts and wash your hands after touching!
|Product ReviewsClick here to review this item|
|For many years I have used double-sided tape to mount similar PCBs. Sometimes hot-melt will work as well, if the board does not get hot of course. A bit of care is always useful too.|
|- Bob, GA|
|Lots of ripple|
|10 mV ripple with no-load. 50 mV with ~1A. But if youre not worried about that, its a pretty good deal.|
|Nice except for mounting.|
|I mounted mine with wire ties that have screw eyes on the end. Works fine.|
|- Roland Phillips, FL|
|Very useful buck converter not boost|
|This is a buck converter - the specs make that clear. This charges my iPhone, which wont charge from a powered USB hub that doesnt respond to USB charge protocol, though some other devices do. Doesnt even get warm when drawing about a half amp at 12V. Im building an off-grid hurricane backup power supply and needed something that would charge any USB device. This seems to be it. Id have given it 5 stars if there was some reasonable way to mount it, but there are no holes and the components come to the edges. Im still trying to figure that out.|
|- Steve, FL|
©2023 Company. All Rights Reserved.