Arduino UNO Acrylic Case Kit


Arduino UNO Acrylic Case Kit
Stock Number: 32182 MP
 Review Average:  
 Number of Reviews: 5
 View ReviewsReview this item
$2.95


Availibilty: In Stock   Units: 2
Quantity 



SHARE
    
     Email this to a friend     

Detailed Description

View PDF Data Sheet
DATA SHEET


Acrylic plastic case for the Arduino UNO-R3 controller.
Protects the UNO from loose wires, dropped parts etc. Case is not water or dust proof. Holes & slots allow access to all UNO connections. Includes Hardware.
ASSEMBLY REQUIRED
UNO NOT INCLUDED
L:W: 2-7/16” T: 7/8” WT: .1


California Proposition 65 Warning WARNING: This product can expose you to chemicals including Nickel which is known to the State of California to cause cancer and which is known to the State of California to cause birth defects and/or other reproductive harm. For more information, go to www.P65Warnings.ca.gov



 Product ReviewsClick here to review this item
A little bit of help
Great look, LOTS of small, mobile parts. I found that putting just a small dot of Goop on each standoff and tacking them to the underside of the board makes positioning it and adding the screws MUCH easier.
- Bryan Krantz, MN
 
fits MPJAs Arduino UNO Clone with WiFi
Removing protective masking is a pain. Screw were all of correct lengths. Not sure whether the additional protection it provides is worthwhile, but it does present a more finished appearance.
 
Verified Purchase
very good service. good product. i will definitely buy again from this seller.l
ebay
 
Shipped fast
Great little box added a touch of class to my project.
 
good case but...
Got one of these for my UNO. nicely cut parts, fit well together. Only issue was that one of screws for holding the case together was too short.