Acrylic plastic case for the Arduino UNO-R3 controller.
Protects the UNO from loose wires, dropped parts etc. Case is not water or dust proof. Holes & slots allow access to all UNO connections. Includes Hardware.
ASSEMBLY REQUIRED
UNO NOT INCLUDED L: 3 W: 2-7/16 T: 7/8 WT: .1
WARNING: This product can expose you to chemicals including Nickel which is known to the State of California to cause cancer and which is known to the State of California to cause birth defects and/or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Click to see Why is this here?
As of August 2018 the State of California has changed the requirements of the Prop 65 law. We now must list on our website any possible chemicals the can cause cancer, birth defects or reproductive problem.
As an example:
ABS plastic contains styrene
PVC wire insulation can contain Di(2-ethylhexyl)phthalate (DEHP)
electrolytic capacitors can contain Ethylene glycol
Brass can contain Lead
flame retardant pc boards can contain Tetrabromobisphenol A (TBBPA)
Aluminum alloys can contain Chromium
To put it simply we are a small company and do not have the resources to test every single part, so we list every thing as hazardous. Please recycle all electronic parts responsibly and under no circumstance eat, drink or smoke these parts and wash your hands after touching!
Great look, LOTS of small, mobile parts.
I found that putting just a small dot of Goop on each standoff and tacking them to the underside of the board makes positioning it and adding the screws MUCH easier.
- Bryan Krantz, MN
fits MPJAs Arduino UNO Clone with WiFi
Removing protective masking is a pain. Screw were all of correct lengths.
Not sure whether the additional protection it provides is worthwhile, but it does present a more finished appearance.
Verified Purchase
very good service. good product. i will definitely buy again from this seller.l
ebay
Shipped fast
Great little box added a touch of class to my project.
good case but...
Got one of these for my UNO. nicely cut parts, fit well together. Only issue was that one of screws for holding the case together was too short.