Special Buy!
Arduino PRO MINI V1.0 AVR Core Development Board with
Installed Bootloader
Arduino ProMini Clone - Get the same power as the UNO, or Nano in a low cost and small footprint. Features a Atmega168, 8bit, 16mHz processor, built in 5V regulator, 8 analog inputs and up to 14 digital I/O pins. This module does not have a USB connector. There are 5 dedicated 100 mil spaced pads for connecting the FTDI cable (DTR,TXO,RXI,VCC,GND) or a USB/TTLconverter module. The ProMini is ideal for use after you have perfected your idea on a Nano or Uno and want to embed it in the final project. Intended for advanced users. 1st. time Users should take advantage of the Arduino Nano to gain skills. Header pins not included. Code libraries, applications and schematics, Information & Freeware available through www. arduino.cc.en and others on-line.
The pre loaded Bootloader, allows Programming with an (off board) USB to TTL converter (our Stock # 31573) or a FTDI smart cable
Processor: Atmega168 @ 16mHz
Power: 5-12VDC RAW On-Board 5 V Regulator
Note: for 5V input Use the Vcc Pin
for 5-12V input Use the RAW pin NOT BOTH
Supply Current 4 – 9mA (no load on I/O)
Analog Inputs: 8 (10-bit ADC)
Digital I/O: 14 (with PWM available on 6)
Memory: Flash: 16K (-2K for bootloader)
SRAM: 1K
EEPROM: 512
Ports: Arduino I/O Pins
6 Pin header for direct wiring to off Board USB connector (Not Supplied)
Manual Reset Button
.1in. pitch holes for I/O headers (NOT Supplied) or direct connection to functions
L: 1-5/6” W: 11/16” H: 1/8” WT: .03
