No Controller/Power Supply-Strip Only
Flexible, IP-67, RGB LED Smart strip with 300, individually controllable Smart 5050SMD RGB LEDs with internal control WS2812B Chip (Data Sheet on Our Website "Support Files".)
5 meter reel with 3-pin JST-SM connector on each end and separate power/ground wires. Note: Requires a 5VDC Output Controller or micro computer (Arduino/-Pi etc.) We Do Not Provide Programming.
Information can be found by Searching "NeoPixel" or "arduino ws2812b library" on the WEB Power Supply: Output: 5VDC @ ~60mA/Section ~ 3.6A/m all LED active. (5m strip can be close to 20A) LED Strip: Single Row, 60 Total LEDs/m
1 LED/Section, 60 Sections/meter Wavelength: R:625nm G:520nm B: 465nm Intensitity: R: ~300mcd, G: ~500mcd, B: ~200mcd
Cutable at 16.5mm (~11/16") (section length)
Minimum Length: 1 Section
Minimum # Active LEDs: 1
Viewing angle: 120°
Protection: IP67 Waterproof cover (If Cut you must Seal to maintain IP67)
Connection: 4" wire leads for additional 5VDC
3-1/2" Wire with 3 pin Male JST-SM on 1 end and 3Pin Female JST-SM on other end (+,- & Data) L: 5M W: 12.5 mm (With Protective Cover) WT: .5
