We do not include any printed materials of the following "Data Sheets". You will need to print from the following Document(s).
MFG: OPENPEAK P/n: OP 20004 Input: 90-132 VAC 60Hz Output: 5VDC @ 4A Specifications/Features: Switching plug supply with overvoltage & current limit protection. Load Regulation +- 5%, Non-Polarized 2 blade input. 6ft output cord with 10mm X 5.5/2.1mm ID Right Angle coaxial plug Center +. UL/canada/usa/listed. RoHS compliant. H: 3-3/8" W: 1-1/2" T: 2-1/4" WT: .3
WARNING: This product can expose you to chemicals including Nickel which is known to the State of California to cause cancer and which is known to the State of California to cause birth defects and/or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Click to see Why is this here?
As of August 2018 the State of California has changed the requirements of the “Prop 65” law. We now must list on our website any possible chemicals the can cause cancer, birth defects or reproductive problem.
As an example:
ABS plastic contains styrene
PVC wire insulation can contain Di(2-ethylhexyl)phthalate (DEHP)
electrolytic capacitors can contain Ethylene glycol
Brass can contain Lead
flame retardant pc boards can contain Tetrabromobisphenol A (TBBPA)
Aluminum alloys can contain Chromium
To put it simply we are a small company and do not have the resources to test every single part, so we list every thing as hazardous. Please recycle all electronic parts responsibly and under no circumstance eat, drink or smoke these parts and wash your hands after touching!
At 1.25 ohms would be 4A@5V
Tested with full length cable = 4.58V at load
Cut cable to 16 = 4.83V.
Cut cable to 3 = 4.9V.
So yes, it will do close to 4A with SHORTER CABLE and better connectors.
- Roger, AR
great little power supply
i bought one of these to test in spite of the review that suggested it did not put out a full 4 amps. i have not yet tested to see how much current it takes to cause it to shut down but it is perfect for my application which draws 2.5 amps peak. a 3 amp supply is not adequate but this one works perfectly and the short circuit protection is well implimented.the output resumes as soon as the short circuit is removed unlike supplies that require you to reset them by unplugging. this little supply is perfect for my application so i just bought 200 of them.
- Spencer Chase, CA
Not good for Raspberry Pi
Works fine if you dont draw too much current, but as soon as my Raspberry Pi draws more than 1.5 A, the voltage drops low enough to cause a low voltage warning on the Pi. Not well regulated and not really capable of 4A.
- Doug, IA
It works
Ive used this power supply for multiple projects now. In one project, I powered a LARGE stepper motor that drew over 2amps. That worked great. Ive also used it to power a Raspberry Pi. It has a status LED on the brick to let you know its on and working. It seems to wait for some kind of stabilization before that light and the output comes on, which is reassuring to me.
Be aware, the white stripe on the cable is not positive. Its ground. That got me bad once.