28 Pin GPIO Breakout Breadboard Kit for Raspberry-Pi,


28 Pin GPIO Breakout Breadboard Kit for Raspberry-Pi,
Stock Number: 33050 MP
 Review Average:  
 Number of Reviews: 2
 View ReviewsReview this item
$10.95


Availibilty: In Stock   Units: 2
Quantity 



SHARE
    
     Email this to a friend     

Detailed Description

Breakout Board and Solderless Breadboard for Raspberry-Pi
Kit Includes:
830 Tie Point Solderless Breadboard
“T” shaped PC Board that plugs into the Solderless Breadboard
7in long, 40pin ribbon cable.
Breaks Out 5V, 3.3V & Gnd as well as 28 GPIO signals:
P0-7, P21-29, CE0&1, SCK, MOS1, MIS0,RX0,TX0, SDA, SCL, SD, SD to the solderless breadboard to provide for easy access to the I/O lines and Power on the Raspberry controller.
Peel-n-stick backer on Breadboard.
LED indicator for 5V power “ON”
“T” Board: L: 2-3/16” W: 2-5/16” H: 3/4” WT: .35


California Proposition 65 Warning WARNING: This product can expose you to chemicals including Nickel which is known to the State of California to cause cancer and which is known to the State of California to cause birth defects and/or other reproductive harm. For more information, go to www.P65Warnings.ca.gov



 Product ReviewsClick here to review this item
GPIO Expansion board NOT as pictured
I am disappointed that the T GPIO expansion board that I received is not the same as the one in the picture. The picture shows the expansion pins @ 0.300 on center, which after insertion into the breadboard leaves ALL four remaining breadboard connections available on BOTH sides of the breadboard. The one I received is on 0.600 center, which covers up three rows of connections. I looked for the SpotPear GPIO version shown in the picture but it does not seem to exist. Maybe there was just not enough room to run the leads in that narrow space. As I did before, Ill cut the breadboard in half and secure it at 0.600 center on the inside rows. :-
- Dale Kline, MI
 
Verified Purchase
Thanks, A+, Fast Shipping
eBay