240 x 320 RGB Pixels 2.8" TFT LCD for Microcontrollers
We do not include any printed materials of the following "Data Sheets". You will need to print from the following Document(s).
2.8" Dia. TFT Color LCD Graphics Module for Micro-controllers.
Uses ILI9341 IC with SPI serial interface
Compatible with 51/ARM/Arduino
Integrated backlight circuit which controls the
backlight and can use the PMW of the arduino to adjust the
On-board SD card expansion connector.
Power: +3.3/5 VDC (On-Board Regulator)
Display Type: 2.8 “TFT” 65K Colors
Resolution: 240 x 320 RGB pixels
Display mode: Transmissive
Backlight: White LED
Viewing Angle: 12 O’clock
Operating Temp: -20 ° C ~ + 70 ° C
Storage Temp: -40 ° C ~ + 70 ° C
Outline Dimensions: 86 * 50 * 7.3 mm
Connections: 14 Pin, 0.1" Pitch Header Pins
Usefull Link: Copy & Paste in Browser
http://www.lcdwiki.com/2.8inch_SPI_Module_ILI9341_SKU:MSP2807 L: 3-3/8” W: 1-1/2” T: 5/16” WT: .1
WARNING: This product can expose you to chemicals including Nickel which is known to the State of California to cause cancer and which is known to the State of California to cause birth defects and/or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Click to see Why is this here?
As of August 2018 the State of California has changed the requirements of the “Prop 65” law. We now must list on our website any possible chemicals the can cause cancer, birth defects or reproductive problem.
As an example:
ABS plastic contains styrene
PVC wire insulation can contain Di(2-ethylhexyl)phthalate (DEHP)
electrolytic capacitors can contain Ethylene glycol
Brass can contain Lead
flame retardant pc boards can contain Tetrabromobisphenol A (TBBPA)
Aluminum alloys can contain Chromium
To put it simply we are a small company and do not have the resources to test every single part, so we list every thing as hazardous. Please recycle all electronic parts responsibly and under no circumstance eat, drink or smoke these parts and wash your hands after touching!
I wish these had the touch function included but they work just fine for a display. If you power this from 3.3 volts you can increase the led backlight intensity by changing resistor R5 on the backside of the pc board to 3.9 ohms the backlight is meant to run on 5 volts. The pin labeled led is the control to a fet, it does not set the current thru the backlight.
MPJA can you locate the 3.5 version of this and stock it? It uses the ILI9488 controller.