We do not include any printed materials of the following "Data Sheets". You will need to print from the following Document(s).
MFG: ZHENGKE P/N: ZGA37RG COIL: 12V/1.1A
Gear motor rated: 30 RPM, 14Kg/cm Torque: 6mm dia. X 14mm flatted steel shaft, bronze bearings. Six M3x0.5 threaded mounting holes in front. Solder terminals L: 2-3/4" (Body) Dia: 1-1/2" WT: .5
WARNING: This product can expose you to chemicals including Nickel which is known to the State of California to cause cancer and which is known to the State of California to cause birth defects and/or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Click to see Why is this here?
As of August 2018 the State of California has changed the requirements of the “Prop 65” law. We now must list on our website any possible chemicals the can cause cancer, birth defects or reproductive problem.
As an example:
ABS plastic contains styrene
PVC wire insulation can contain Di(2-ethylhexyl)phthalate (DEHP)
electrolytic capacitors can contain Ethylene glycol
Brass can contain Lead
flame retardant pc boards can contain Tetrabromobisphenol A (TBBPA)
Aluminum alloys can contain Chromium
To put it simply we are a small company and do not have the resources to test every single part, so we list every thing as hazardous. Please recycle all electronic parts responsibly and under no circumstance eat, drink or smoke these parts and wash your hands after touching!
This is a good motor and gear reduction, its not great. It has good torque but is somewhat noisy. My application is very low duty cycle, perhaps 30 seconds a day. The output shaft is a low quality bronze bushing and has some slop. One of the six M3 screw mounting points was bad, other 5 were fine. I expect long life with my low usage. Overall a good value and would purchase again. If you need higher precision spend more.
Works very well, Lots of torque.
Doesnt last very long
I bought 2 or more of these motors and the first time using it it stopped running less than 600 hours of op. Put in second motor and measured current draw, less than 450 mA so motor not overloaded if the 1.1 amp spec is real. Beware these may be factory seconds!